MARCOS PIZZA #8126

3 findings recorded on Nov 5, 2026.

1. Violation recordedItem 15A ↗

   Equipment design and condition

   Observed a reach-in cooler gasket to be ripped. Good Repair & Proper Adjustment (C) (6) Maintenance and Operation.

   Inspector’s full note

   Inspection item: Food and nonfood-contact surfaces cleanable, properly designed, constructed, and used

   Code 511-6-1.05(6)(a)

   Observed a reach-in cooler gasket to be ripped. Good Repair & Proper Adjustment (C) (6) Maintenance and Operation. (a) Good Repair and Proper Adjustment. 1. Equipment shall be maintained in a state of repair and condition that meets the requirements specified under subsections (1) and (2)of this Rule. 2. Equipment components such as doors, seals, hinges, fasteners, and kick plates shall be kept intact, tight, and adjusted in accordance with manufacturer's specifications. Note: PIC stated a new gasket would be purchased and installed. New Violation.

   Official report · Item 15A ↗

   Correction status not recorded

2. Violation recordedItem 15C ↗

   Equipment cleanliness

   Observed a build-up of a black mold-like material on the gaskets of a reach-in cooler and walk-in cooler. Equipment, Food/Nonfood-Contact Surfaces, and Utensils, food-contact surfaces of cooking equipment & nonfood-contact surfaces free of accumulations (C) 2.

   Inspector’s full note

   Inspection item: Nonfood-contact surfaces clean

   Code 511-6-1.05(7)(a)2,3

   Observed a build-up of a black mold-like material on the gaskets of a reach-in cooler and walk-in cooler. Equipment, Food/Nonfood-Contact Surfaces, and Utensils, food-contact surfaces of cooking equipment & nonfood-contact surfaces free of accumulations (C) 2. The food-contact surfaces of cooking equipment and pans shall be kept free of encrusted grease deposits and other soil accumulations. 3. Nonfood-contact surfaces of equipment shall be kept free of an accumulation of dust, dirt, food residue, and other debris. Note: PIC stated that the gaskets would be cleaned at COB. New Violation.

   Official report · Item 15C ↗

   Correction status not recorded

3. Repeat violationItem 16B ↗

   Plumbing and drainage

   Observed backflow device at the mop sink to be leaking when the sink is turned on. System Maintained in Good Repair (P, C) (r) System Maintained in Good Repair.

   Inspector’s full note

   Inspection item: Plumbing installed; proper backflow devices

   Code 511-6-1.06(2)(r)

   Observed backflow device at the mop sink to be leaking when the sink is turned on. System Maintained in Good Repair (P, C) (r) System Maintained in Good Repair. A plumbing system shall be repaired according to law; P and maintained in good repair. Note: PIC stated the backflow device would be repaired. Repeat Violation.

   Official report · Item 16B ↗

   Correction status not recorded

Correction status comes from the dated report. Later changes may not be recorded here.