Bizarre Coffee Roswell

3 findings recorded on Oct 1, 2026.

1. Violation recordedItem 4-2B ↗

   Food-contact surface sanitation

   Observed mechanical ware wash machine had no sanitizer in it. PIC advised to refill the sanitizer for the ware wash machine and use the 3 compartment sink until the dishwasher has sanitizer replaced.

   Inspector’s full note

   Inspection item: Food-contact surfaces: cleaned & sanitized

   Code 511-6-1.05(6)(n)

   Observed mechanical ware wash machine had no sanitizer in it. PIC advised to refill the sanitizer for the ware wash machine and use the 3 compartment sink until the dishwasher has sanitizer replaced. 511-6-1.05(6)(n) - Manual and Mechanical Warewashing Equipment, Chemical Sanitization-Temperature, pH, Concentration, Hardness (P,Pf) (n) Manual and Mechanical Warewashing Equipment, Chemical Sanitization - Temperature, pH, Concentration, and Hardness. A chemical sanitizer used in a sanitizing solution for a manual or mechanical operation at contact times specified under subsection (8)(b)3 of this Rule shall meet the requirements specified in DPH Rule 511-6-1-.07(6)(g), shall be used in accordance with the Environmental Protection Agency (EPA)-registered label use instructions P, and shall be used as follows: 1. A chlorine solution shall have a minimum temperature based on the concentration and pH of the solution as listed in the following chart; P Concentration Range Minimum Temperature MG/L PH 10 or less oF (oC) PH 8 or less oF (oC) 25-49 120 (49) 120 (49) 50-99 100 (38) 75 (24) 100 55 (13) 55 (13) 2. An iodine solution shall have a minimum temperature of 68°F (20°C)P minimum concentration between 12.5 ppm and 25 ppm, P and pH of 5.0 or less or a pH no higher than the level for which the manufacturer specifies for the solution to be effective; P 3. A quaternary ammonium compound solution shall have a minimum temperature of 75ºF (24ºC), P have a concentration as specified in DPH Rule 511-6-1-.07(6)(g) and as indicated by the manufacturer’s use directions included in the labeling, P and be used only in water with 500 ppm hardness or less or in water having a hardness no greater than specified by the EPA-registered label use instructions; P 4. If another solution of a chemical specified under paragraphs 1 through 3 of this subsection is used, the permit holder shall demonstrate to the Health Authority that the solution achieves sanitization and the use of the solution shall be approved; P 5. If a chemical sanitizer other than chlorine, iodine, or a quaternary ammonium compound is used, it shall be applied in accordance with the EPA-registered label use instructions ;P and 6. If a chemical sanitizer is generated by a device located on-site at the food service establishment, it shall be used as specified in 1-5 of this subsection and shall be produced by a device that: (i) complies with law as specified in sections 2(q)(1) and 12 of the Federal Insecticide, Fungicide, and Rodenticide Act (FIFRA), P (ii) complies with 40 CFR 152.500 Requirement for Devices and 40 CFR 156.10 Labeling Requirements, P (iii) displays the EPA device manufacturing facility registration number on the device, Pf and (iv) is operated and maintained in accordance with manufacturer’s instructions. Pf. 7. On-site chemical sanitizer generating equipment with active ingredients, such as copper, must be registered as pesticides. The active ingredient may be part of the equipment or separately added. New Violation. Correct By: 10/05/2026

   Official report · Item 4-2B ↗

   Correction status not recorded

   Correct by Oct 5, 2026

2. Violation recordedItem 15A ↗

   Equipment design and condition

   Observed significant wear on cutting board in main kitchen. PIC advised to replace it with the new board.

   Inspector’s full note

   Inspection item: Food and nonfood-contact surfaces cleanable, properly designed, constructed, and used

   Code 511-6-1.05(6)(b)

   Observed significant wear on cutting board in main kitchen. PIC advised to replace it with the new board. 511-6-1.05(6)(b) - Cutting Surfaces (C) (b) Cutting Surfaces. Surfaces such as cutting blocks and boards that are subject to scratching and scoring shall be resurfaced if they can no longer be effectively cleaned and sanitized, or discarded if they cannot be resurfaced. New Violation. Correct By: 10/02/2026

   Official report · Item 15A ↗

   Correction status not recorded

   Correct by Oct 2, 2026

3. Violation recordedItem 15B ↗

   Warewashing facilities and test strips

   At the time of inspection, PIC failed to provide testing strips for the 3 compartment sink sanitizer test. PIC advised to order them ASAP.

   Inspector’s full note

   Inspection item: Warewashing facilities: installed, maintained, used; test strips

   Code 511-6-1.05(3)(h),(i),(j)

   At the time of inspection, PIC failed to provide testing strips for the 3 compartment sink sanitizer test. PIC advised to order them ASAP. 511-6-1.05(3)(h),(i),(j) - Temperature Measuring Device, Manual Warewashing; Sanitizing Solutions, Testing Device (Pf) (h) Temperature Measuring Devices, Manual and Mechanical Warewashing. 1. In manual warewashing operations, a temperature measuring device shall be provided and readily accessible for frequently measuring the washing and sanitizing temperatures. Pf 2. In hot water mechanical warewashing operations, an irreversible registering temperature indicator shall be provided and readily accessible for measuring the utensil surface temperature. Pf (i) Sanitizing Solutions, Testing Devices. A test kit or other device that accurately measures the concentration in mg/L of sanitizing solutions shall be provided. Pf j) Cleaning Agents and Sanitizers. 1. Cleaning agents that are used to clean equipment and utensils as specified under section (7) of this Rule, shall be provided and available for use during all hours of operation. Pf 2. Except for those that are generated on-site at the time of use, chemical sanitizers that are used to sanitize equipment and utensils, as specified under Section (8) of this Rule, shall be provided and available for use during all hours of operation. Pf New Violation. Correct By: 10/02/2026

   Official report · Item 15B ↗

   Correction status not recorded

   Correct by Oct 2, 2026

Correction status comes from the dated report. Later changes may not be recorded here.