Bizarre Coffee Roswell received an A, scoring 95 out of 100, in a Fulton County food-service inspection on Oct 1, 2026. The official report lists three findings. [1]
The inspector observed mechanical ware wash machine had no sanitizer in it. [2]
The inspector also observed significant wear on cutting board in main kitchen. [3]
The report states: “At the time of inspection, PIC failed to provide testing strips for the 3 compartment sink sanitizer test.” [4]
Showing 3 of 3 findings
Observed mechanical ware wash machine had no sanitizer in it. PIC advised to refill the sanitizer for the ware wash machine and use the 3 compartment sink until the dishwasher has sanitizer replaced.
Code 511-6-1.05(6)(n)
Observed mechanical ware wash machine had no sanitizer in it. PIC advised to refill the sanitizer for the ware wash machine and use the 3 compartment sink until the dishwasher has sanitizer replaced. 511-6-1.05(6)(n) - Manual and Mechanical Warewashing Equipment, Chemical Sanitization-Temperature, pH, Concentration, Hardness (P,Pf) (n) Manual and Mechanical Warewashing Equipment, Chemical Sanitization - Temperature, pH, Concentration, and Hardness. A chemical sanitizer used in a sanitizing solution for a manual or mechanical operation at contact times specified under subsection (8)(b)3 of this Rule shall meet the requirements specified in DPH Rule 511-6-1-.07(6)(g), shall be used in accordance with the Environmental Protection Agency (EPA)-registered label use instructions P, and shall be used as follows: 1. A chlorine solution shall have a minimum temperature based on the concentration and pH of the solution as listed in the following chart; P Concentration Range Minimum Temperature MG/L PH 10 or less oF (oC) PH 8 or less oF (oC) 25-49 120 (49) 120 (49) 50-99 100 (38) 75 (24) 100 55 (13) 55 (13) 2. An iodine solution shall have a minimum temperature of 68°F (20°C)P minimum concentration between 12.5 ppm and 25 ppm, P and pH of 5.0 or less or a pH no higher than the level for which the manufacturer specifies for the solution to be effective; P 3. A quaternary ammonium compound solution shall have a minimum temperature of 75ºF (24ºC), P have a concentration as specified in DPH Rule 511-6-1-.07(6)(g) and as indicated by the manufacturer’s use directions included in the labeling, P and be used only in water with 500 ppm hardness or less or in water having a hardness no greater than specified by the EPA-registered label use instructions; P 4. If another solution of a chemical specified under paragraphs 1 through 3 of this subsection is used, the permit holder shall demonstrate to the Health Authority that the solution achieves sanitization and the use of the solution shall be approved; P 5. If a chemical sanitizer other than chlorine, iodine, or a quaternary ammonium compound is used, it shall be applied in accordance with the EPA-registered label use instructions ;P and 6. If a chemical sanitizer is generated by a device located on-site at the food service establishment, it shall be used as specified in 1-5 of this subsection and shall be produced by a device that: (i) complies with law as specified in sections 2(q)(1) and 12 of the Federal Insecticide, Fungicide, and Rodenticide Act (FIFRA), P (ii) complies with 40 CFR 152.500 Requirement for Devices and 40 CFR 156.10 Labeling Requirements, P (iii) displays the EPA device manufacturing facility registration number on the device, Pf and (iv) is operated and maintained in accordance with manufacturer’s instructions. Pf. 7. On-site chemical sanitizer generating equipment with active ingredients, such as copper, must be registered as pesticides. The active ingredient may be part of the equipment or separately added. New Violation. Correct By: 10/05/2026Official report · Item 4-2B ↗
Correct by
Observed significant wear on cutting board in main kitchen. PIC advised to replace it with the new board.
Code 511-6-1.05(6)(b)
Observed significant wear on cutting board in main kitchen. PIC advised to replace it with the new board. 511-6-1.05(6)(b) - Cutting Surfaces (C) (b) Cutting Surfaces. Surfaces such as cutting blocks and boards that are subject to scratching and scoring shall be resurfaced if they can no longer be effectively cleaned and sanitized, or discarded if they cannot be resurfaced. New Violation. Correct By: 10/02/2026Official report · Item 15A ↗
Correct by
At the time of inspection, PIC failed to provide testing strips for the 3 compartment sink sanitizer test. PIC advised to order them ASAP.
Code 511-6-1.05(3)(h),(i),(j)
At the time of inspection, PIC failed to provide testing strips for the 3 compartment sink sanitizer test. PIC advised to order them ASAP. 511-6-1.05(3)(h),(i),(j) - Temperature Measuring Device, Manual Warewashing; Sanitizing Solutions, Testing Device (Pf) (h) Temperature Measuring Devices, Manual and Mechanical Warewashing. 1. In manual warewashing operations, a temperature measuring device shall be provided and readily accessible for frequently measuring the washing and sanitizing temperatures. Pf 2. In hot water mechanical warewashing operations, an irreversible registering temperature indicator shall be provided and readily accessible for measuring the utensil surface temperature. Pf (i) Sanitizing Solutions, Testing Devices. A test kit or other device that accurately measures the concentration in mg/L of sanitizing solutions shall be provided. Pf j) Cleaning Agents and Sanitizers. 1. Cleaning agents that are used to clean equipment and utensils as specified under section (7) of this Rule, shall be provided and available for use during all hours of operation. Pf 2. Except for those that are generated on-site at the time of use, chemical sanitizers that are used to sanitize equipment and utensils, as specified under Section (8) of this Rule, shall be provided and available for use during all hours of operation. Pf New Violation. Correct By: 10/02/2026Official report · Item 15B ↗
Correct by
Correction and repeat labels quote the report. An absent label leaves correction status unknown; a deadline does not confirm a correction.
Fulton County · Oct 1, 2026
02 / Same facility ↗Official inspection historyAvailable records for this official facility
03 / How scoring works ↗Georgia’s food-service rulesScores and findings describe the dated inspection, not current operating conditions. A correction deadline does not establish whether an issue remained unresolved afterward.
Findings quote the official report captured . “Corrected on site” and “repeat” reflect explicit report markers. “COS” and “CA” in the inspector’s notes refer to corrections and corrective actions; an instruction to act is not proof that it was completed.
History links the same official facility ID within the issuing authority and may omit intervening inspections. Same-day results have no inferred sequence. Report excerpts follow source order, not a severity ranking.
This report comes from Fulton County. History includes only this authority’s exact facility ID.
Checked