14th Street NE Catering LLC d/b/a AC Marriott/Moxy Atlanta (Rooftop Kitchen Bar)

2 findings recorded on Sep 10, 2026. 1 marked corrected on site.

1. Violation recordedItem 6-1A ↗

   Cold holding

   Observed shredded beef and grilled chicken stored in the RIC out of temp and exceeding 41 degrees F. Both items reached 45 degrees F.

   Inspector’s full note

   Inspection item: Proper cold holding temperatures

   Code 511-6-1.04(6)(f)

   Observed shredded beef and grilled chicken stored in the RIC out of temp and exceeding 41 degrees F. Both items reached 45 degrees F. COS: Food was discarded and EHS advised PIC to discard all foods stored in the unit as the ambient temp was 45 degrees. Corrected On-Site. New Violation.

   Official report · Item 6-1A ↗

   Marked corrected on site

2. Repeat violationItem 15A ↗

   Equipment design and condition

   Observed the gaskets of the RIC and Ice machine in need of replacement. CA: Equipment components such as doors, seals, hinges, fasteners, and kick plates shall be kept intact, tight, and adjusted in accordance with manufacturer's specifications.

   Inspector’s full note

   Inspection item: Food and nonfood-contact surfaces cleanable, properly designed, constructed, and used

   Code 511-6-1.05(6)(a)

   Observed the gaskets of the RIC and Ice machine in need of replacement. CA: Equipment components such as doors, seals, hinges, fasteners, and kick plates shall be kept intact, tight, and adjusted in accordance with manufacturer's specifications. CA: PIC has in place a workorder for the gaskets Violation Code Reference 511-6-1.05(6)(a) - Good Repair & Proper Adjustment (C) (6) Maintenance and Operation. (a) Good Repair and Proper Adjustment. 1. Equipment shall be maintained in a state of repair and condition that meets the requirements specified under subsections (1) and (2)of this Rule. 2. Equipment components such as doors, seals, hinges, fasteners, and kick plates shall be kept intact, tight, and adjusted in accordance with manufacturer's specifications. 3. Cutting or piercing parts of can openers shall be kept sharp to minimize the creation of metal fragments that can contaminate food when the container is opened. Repeat Violation. Correct By: 09/14/2026

   Official report · Item 15A ↗

   Correction status not recorded

   Correct by Sep 14, 2026

Correction status comes from the dated report. Later changes may not be recorded here.