MR COW

2 findings recorded on Aug 28, 2026. 1 marked corrected on site.

1. Repeat violationItem 4-2B ↗

   Food-contact surface sanitation

   Mold was observed on the soda nozzles. CA: Equipment food-contact surfaces and utensils shall be clean to sight and touch.

   Inspector’s full note

   Inspection item: Food-contact surfaces: cleaned & sanitized

   Code 511-6-1.05(7)(a)1

   Mold was observed on the soda nozzles. CA: Equipment food-contact surfaces and utensils shall be clean to sight and touch. COS: The soda nozzles were cleaned and sanitized. Repeat Violation.

   Official report · Item 4-2B ↗

   Correction status not recorded

2. Violation recordedItem 4-2B ↗

   Food-contact surface sanitation

   The sanitizer concentration at the 3-compartment sink was tested and measured at 0PPM. CA: Manual and Mechanical Warewashing Equipment, Chemical Sanitization - Temperature, pH, Concentration, and Hardness.

   Inspector’s full note

   Inspection item: Food-contact surfaces: cleaned & sanitized

   Code 511-6-1.05(6)(n)

   The sanitizer concentration at the 3-compartment sink was tested and measured at 0PPM. CA: Manual and Mechanical Warewashing Equipment, Chemical Sanitization - Temperature, pH, Concentration, and Hardness. A chemical sanitizer used in a sanitizing solution for a manual or mechanical operation at contact times specified under subsection (8)(b)3 of this Rule shall meet the requirements specified in DPH Rule 511-6-1-.07(6)(g), shall be used in accordance with the Environmental Protection Agency (EPA)-registered label use instructions. COS: The sanitizer at the 3-compartment sink measured 50PPM for chlorine. Corrected On-Site. New Violation.

   Official report · Item 4-2B ↗

   Marked corrected on site

Correction status comes from the dated report. Later changes may not be recorded here.