Tipsy Thaiger

2 findings recorded on Oct 20, 2026. 1 marked corrected on site.

1. Violation recordedItem 4-2B ↗

   Food-contact surface sanitation

   Observed dishwasher in the bar area is not dispensing sanitizer. PIC is advised to use the dishwasher in the main kitchen until the sanitizer issue is fixed in the bar area.

   Inspector’s full note

   Inspection item: Food-contact surfaces: cleaned & sanitized

   Code 511-6-1.05(6)(n)

   Observed dishwasher in the bar area is not dispensing sanitizer. PIC is advised to use the dishwasher in the main kitchen until the sanitizer issue is fixed in the bar area. 511-6-1.05(6)(n) - Manual and Mechanical Warewashing Equipment, Chemical Sanitization-Temperature, pH, Concentration, Hardness (P,Pf) (n) Manual and Mechanical Warewashing Equipment, Chemical Sanitization - Temperature, pH, Concentration, and Hardness. A chemical sanitizer used in a sanitizing solution for a manual or mechanical operation at contact times specified under subsection (8)(b)3 of this Rule shall meet the requirements specified in DPH Rule 511-6-1-.07(6)(g), shall be used in accordance with the Environmental Protection Agency (EPA)-registered label use instructions P, and shall be used as follows: 1. A chlorine solution shall have a minimum temperature based on the concentration and pH of the solution as listed in the following chart; P Concentration Range Minimum Temperature MG/L PH 10 or less oF (oC) PH 8 or less oF (oC) 25-49 120 (49) 120 (49) 50-99 100 (38) 75 (24) 100 55 (13) 55 (13) 2. An iodine solution shall have a minimum temperature of 68°F (20°C)P minimum concentration between 12.5 ppm and 25 ppm, P and pH of 5.0 or less or a pH no higher than the level for which the manufacturer specifies for the solution to be effective; P 3. A quaternary ammonium compound solution shall have a minimum temperature of 75ºF (24ºC), P have a concentration as specified in DPH Rule 511-6-1-.07(6)(g) and as indicated by the manufacturer’s use directions included in the labeling, P and be used only in water with 500 ppm hardness or less or in water having a hardness no greater than specified by the EPA-registered label use instructions; P 4. If another solution of a chemical specified under paragraphs 1 through 3 of this subsection is used, the permit holder shall demonstrate to the Health Authority that the solution achieves sanitization and the use of the solution shall be approved; P 5. If a chemical sanitizer other than chlorine, iodine, or a quaternary ammonium compound is used, it shall be applied in accordance with the EPA-registered label use instructions ;P and 6. If a chemical sanitizer is generated by a device located on-site at the food service establishment, it shall be used as specified in 1-5 of this subsection and shall be produced by a device that: (i) complies with law as specified in sections 2(q)(1) and 12 of the Federal Insecticide, Fungicide, and Rodenticide Act (FIFRA), P (ii) complies with 40 CFR 152.500 Requirement for Devices and 40 CFR 156.10 Labeling Requirements, P (iii) displays the EPA device manufacturing facility registration number on the device, Pf and (iv) is operated and maintained in accordance with manufacturer’s instructions. Pf. 7. On-site chemical sanitizer generating equipment with active ingredients, such as copper, must be registered as pesticides. The active ingredient may be part of the equipment or separately added. Corrected On-Site. New Violation.

   Official report · Item 4-2B ↗

   Marked corrected on site

2. Violation recordedItem 9-2 ↗

   Specialized process compliance

   Observed the facility had ROP meat in the RIC. Facility does not have an approved HAACP plan for ROP of meat.

   Inspector’s full note

   Inspection item: Compliance with variance, specialized process and HACCP plan

   Code 511-6-1.02(5)(a)(b)

   Observed the facility had ROP meat in the RIC. Facility does not have an approved HAACP plan for ROP of meat. PIC advised to send the HACCP plan to get an approval from the state. 511-6-1.02(5)(a)(b) - When a HACCP plan is Required (C) (a) Before engaging in an activity that requires a HACCP plan, a permit applicant or permit holder shall submit to the local Health Authority for joint review by the State Office of Environmental Health and the local Health Authority, a properly prepared HACCP plan as specified under DPH Rule 511-6-1-.02(6) and the relevant provisions of this Code if: 1. Submission of a HACCP plan is required according to the Chapter; 2. A variance is required as specified DPH Rule 511-6-1-.04(5)(a)4(iv), 511-6-1-.04(6)(j), or 511-6-1-.05(2)(v)2; 3. The local Health Authority determines that a food preparation or processing method requires a variance based on a plan submittal specified under DPH Rule 511-6-1-.02(4)(b), or an inspectional finding, or a variance request. (b) Before engaging in Reduced Oxygen Packaging without a variance as specified in DPH Rule 511-6-1-.04(6)(k), a permit applicant or permit holder shall submit a properly prepared HACCP plan to the Health Authority. New Violation. Correct By: 10/27/2026

   Official report · Item 9-2 ↗

   Correction status not recorded

   Correct by Oct 27, 2026

Correction status comes from the dated report. Later changes may not be recorded here.