Marlow's Tavern receives B in Fulton County health inspection

1. 01

   Food-contact surface sanitation

   Item 4-2B ↗

   Observed oven and panini press in the main kitchen had grime and food buildup. PIC advised to clean the surfaces regularly.

   Inspector’s full note +

   Code 511-6-1.05(7)(a)1

   Observed oven and panini press in the main kitchen had grime and food buildup. PIC advised to clean the surfaces regularly. 511-6-1.05(7)(a)1 - Equipment, Food-Contact Surfaces,& Utensils (Pf) (7) Cleaning of Equipment and Utensils. (a) Equipment, Food-Contact Surfaces, and Utensils. 1. Equipment food-contact surfaces and utensils shall be clean to sight and touch. Pf. New Violation. Correct By: 11/05/2026

   Official report · Item 4-2B ↗
   New violation

   Correct by
   Nov 5, 2026

2. 02

   Food-contact surface sanitation

   Item 4-2B ↗

   Observed dishwasher in the bar area is not dispensing sanitizer. PIC advised to use the dishwasher in main kitchen until this is fixed.

   Inspector’s full note +

   Code 511-6-1.05(6)(n)

   Observed dishwasher in the bar area is not dispensing sanitizer. PIC advised to use the dishwasher in main kitchen until this is fixed. 511-6-1.05(6)(n) - Manual and Mechanical Warewashing Equipment, Chemical Sanitization-Temperature, pH, Concentration, Hardness (P,Pf) (n) Manual and Mechanical Warewashing Equipment, Chemical Sanitization - Temperature, pH, Concentration, and Hardness. A chemical sanitizer used in a sanitizing solution for a manual or mechanical operation at contact times specified under subsection (8)(b)3 of this Rule shall meet the requirements specified in DPH Rule 511-6-1-.07(6)(g), shall be used in accordance with the Environmental Protection Agency (EPA)-registered label use instructions P, and shall be used as follows: 1. A chlorine solution shall have a minimum temperature based on the concentration and pH of the solution as listed in the following chart; P Concentration Range Minimum Temperature MG/L PH 10 or less oF (oC) PH 8 or less oF (oC) 25-49 120 (49) 120 (49) 50-99 100 (38) 75 (24) 100 55 (13) 55 (13) 2. An iodine solution shall have a minimum temperature of 68°F (20°C)P minimum concentration between 12.5 ppm and 25 ppm, P and pH of 5.0 or less or a pH no higher than the level for which the manufacturer specifies for the solution to be effective; P 3. A quaternary ammonium compound solution shall have a minimum temperature of 75ºF (24ºC), P have a concentration as specified in DPH Rule 511-6-1-.07(6)(g) and as indicated by the manufacturer’s use directions included in the labeling, P and be used only in water with 500 ppm hardness or less or in water having a hardness no greater than specified by the EPA-registered label use instructions; P 4. If another solution of a chemical specified under paragraphs 1 through 3 of this subsection is used, the permit holder shall demonstrate to the Health Authority that the solution achieves sanitization and the use of the solution shall be approved; P 5. If a chemical sanitizer other than chlorine, iodine, or a quaternary ammonium compound is used, it shall be applied in accordance with the EPA-registered label use instructions ;P and 6. If a chemical sanitizer is generated by a device located on-site at the food service establishment, it shall be used as specified in 1-5 of this subsection and shall be produced by a device that: (i) complies with law as specified in sections 2(q)(1) and 12 of the Federal Insecticide, Fungicide, and Rodenticide Act (FIFRA), P (ii) complies with 40 CFR 152.500 Requirement for Devices and 40 CFR 156.10 Labeling Requirements, P (iii) displays the EPA device manufacturing facility registration number on the device, Pf and (iv) is operated and maintained in accordance with manufacturer’s instructions. Pf. 7. On-site chemical sanitizer generating equipment with active ingredients, such as copper, must be registered as pesticides. The active ingredient may be part of the equipment or separately added. Corrected On-Site. New Violation.

   Official report · Item 4-2B ↗
   Corrected on siteNew violation
3. 03

   Cold holding

   Item 6-1A ↗

   Observed several TCS foods like cut tomatoes, Chicken wings, dairy based sauces were not maintaining temperatures at or below 41F in the prep top cooler and RIC in the main kitchen. PIC moved the food to freeezer for rapid cooling and is advised to not use the RIC until it is fixed.

   Inspector’s full note +

   Code 511-6-1.04(6)(f)

   Observed several TCS foods like cut tomatoes, Chicken wings, dairy based sauces were not maintaining temperatures at or below 41F in the prep top cooler and RIC in the main kitchen. PIC moved the food to freeezer for rapid cooling and is advised to not use the RIC until it is fixed. 511-6-1.04(6)(f) - Time/Temperature Control for Safety; Cold Holding (P) (f) Time/Temperature Control for Safety Food, Hot and Cold Holding. Except during preparation, cooking, or cooling, or when time is used as the public health control, time/temperature control for safety food shall be maintained at 41°F (5°C) or below or 135°F (57°C) or above, except that roasts cooked to a temperature and for a time specified in subsection (5)(a)2 of this Rule and reheated using the same temperature and time conditions as cooking may be held at a temperature of 130°F (54°C) or above. P Corrected On-Site. Repeat Violation.

   Official report · Item 6-1A ↗
   Corrected on siteRepeat violation
4. 04

   Warewashing facilities and test strips

   Item 15B ↗

   At the time of inspection, PIC failed to provide a temperature checking device to confirm the rinse temperature of ware washer in the main kitchen and the temperature gauge was broken. PIC advised to get the gauge fixed ASAP.

   Inspector’s full note +

   Code 511-6-1.05(3)(h),(i),(j)

   At the time of inspection, PIC failed to provide a temperature checking device to confirm the rinse temperature of ware washer in the main kitchen and the temperature gauge was broken. PIC advised to get the gauge fixed ASAP. New Violation. Correct By: 11/10/2026

   Official report · Item 15B ↗
   New violation

   Correct by
   Nov 10, 2026

Correction and repeat labels quote the report. An absent label leaves correction status unknown; a deadline does not confirm a correction.