Campbell Stone received an A, scoring 92 out of 100, in a Fulton County food-service inspection on Sep 17, 2026. The official report lists five findings. [1]
The inspector observed pink residue build up on the inside of the ice machine. [2]
The inspector also observed salmon thawed in WIC while still in vacuum sealed packaging. The note records an on-site correction: “PIC removed tuna from vacuum sealed packaging.” [3]
A separate finding described lack of quat test strips inside facility. [4]
The report marks one finding as corrected on site. [5]
Showing 5 of 5 findings
Observed pink residue build up on the inside of the ice machine. CA: Advised PIC to routinely clean inside ice machine to prevent build up.
Code 511-6-1.05(7)(b)
Observed pink residue build up on the inside of the ice machine. CA: Advised PIC to routinely clean inside ice machine to prevent build up. 511-6-1.05(7)(b) - Food Contact Surfaces and Utensils - Cleaning Frequency (P, C) (b) Equipment Food-Contact Surfaces and Utensils. 1. Equipment food-contact surfaces and utensils shall be cleaned: (i) Before each use with a different type of raw animal food such as beef, fish, lamb, pork, or poultry. It does not apply if the food-contact surface or utensil is in contact with a succession of different types of raw meat and raw poultry each requiring a higher cooking temperature as specified under DPH Rule 511-6-1.04(5)(a) than the previous type such as preparing raw pork followed by cutting raw poultry on the same cutting board; P (ii) Each time there is a change from working with raw foods to working with ready-to-eat foods; P (iii) Between uses with raw fruits and vegetables and with Time/Temperature Control for safety food; P (iv) Before using or storing a food temperature measuring device; P and (v) At any time during the operation when contamination may have occurred. P 2. Except as specified in paragraph 3 of this subsection, if used with time/temperature control for safety food, equipment food-contact surfaces and utensils shall be cleaned at least every 4 hours throughout the day. P 3. Surfaces of utensils and equipment contacting time/temperature control for safety food may be cleaned less frequently than every 4 hours if: (i) In storage, containers of time/temperature control for safety food and their contents are maintained at temperatures specified under DPH Rule 511-6-1-.04 and the containers are cleaned when they are empty; (ii) Utensils and equipment are used to prepare food in a refrigerated room or area that is maintained at one of the temperatures in the following chart and: (I) The utensils and equipment are cleaned at the frequency in the following chart that corresponds to the temperature: Temperature Cleaning Frequency 41ºF (5.0ºC) or less 24 hours >41ºF - 45ºF (>5.0ºC - 7.2ºC) 20 hours >45ºF - 50ºF (>7.2ºC - 10.0ºC) 16 hours >50ºF - 55ºF (>10.0ºC - 12.8ºC) 10 hours and (II) The cleaning frequency based on the ambient temperature of the refrigerated room or area is documented in the food service establishment. (iii) Temperature measuring devices are maintained in contact with food, such as when left in a container of deli food or in a roast, held at temperatures specified under DPH Rule 511-6-1- .04; (iv) Equipment is used for storage of packaged or unpackaged food, such as a reach-in refrigerator, and the equipment is cleaned at a frequency necessary to preclude accumulation of soil residues; (v) The cleaning schedule is approved based on consideration of: (I) Characteristics of the equipment and its use, (II) The type of food involved, (III) The amount of food residue accumulation, and (IV) The temperature at which the food is maintained during the operation and the potential for the rapid and progressive multiplication of pathogenic or toxigenic microorganisms that are capable of causing foodborne disease; or (vi) In-use utensils are intermittently stored in a container of water in which the water is maintained at 135ºF (57ºC) or more and the utensils and container are cleaned at least every 24 hours or at a frequency necessary to preclude accumulation of soil residues. 4. Dining counters and table-tops shall be cleaned and sanitized routinely after removing all soiled tableware and food trays shall be cleaned and sanitized after each use by one of the following methods: (i) A two step method in which one cloth, rinsed in sanitizing solution is used to clean food debris from the surface and a second cloth in separate sanitizing solution is used to rinse; (ii) Sanitizing solution is sprayed onto the surface and the surface is then wiped clean with a disposable towel; (iii) If used for cleaning and sanitizing, single-use disposable sanitizer wipes shall be used in accordance with EPA-registered label use instructions; or (iv) Other methods approved by the Health Authority. (v) Food trays may be cleaned and sanitized the same as table ware. 5. Except when dry cleaning methods are used as specified under subsection (7)(e) of this Rule, surfaces of utensils and equipment contacting food that is not time/temperature control for safety food shall be cleaned: (i) At any time when contamination may have occurred; (ii) At least every 24 hours for iced tea dispensers including nozzles and consumer self-service utensils such as tongs, scoops, or ladles; (iii) Before restocking consumer self-service equipment and utensils such as condiment dispensers and display containers; and (iv) In equipment such as ice bins and beverage dispensing nozzles and enclosed components of equipment such as ice makers, cooking oil storage tanks and distribution lines, beverage and syrup dispensing lines or tubes, coffee bean grinders, and water vending equipment: (I) At a frequency specified by the manufacturer; or (II) Absent manufacturer specifications, at a frequency necessary to preclude accumulation of soil or mold. New Violation. Correct By: 09/18/2026Official report · Item 4-2B ↗
Correct by
Observed 0ppm quat bucket. Quat sanitizer container was empty.
Code 511-6-1.05(6)(n)
Observed 0ppm quat bucket. Quat sanitizer container was empty. PIC stated SuperSource comes by every week to restock sanitizers. CA: Advised PIC to restock sanitizer. 511-6-1.05(6)(n) - Manual and Mechanical Warewashing Equipment, Chemical Sanitization-Temperature, pH, Concentration, Hardness (P,Pf) (n) Manual and Mechanical Warewashing Equipment, Chemical Sanitization - Temperature, pH, Concentration, and Hardness. A chemical sanitizer used in a sanitizing solution for a manual or mechanical operation at contact times specified under subsection (8)(b)3 of this Rule shall meet the requirements specified in DPH Rule 511-6-1-.07(6)(g), shall be used in accordance with the Environmental Protection Agency (EPA)-registered label use instructions P, and shall be used as follows: 1. A chlorine solution shall have a minimum temperature based on the concentration and pH of the solution as listed in the following chart; P Concentration Range Minimum Temperature MG/L PH 10 or less oF (oC) PH 8 or less oF (oC) 25-49 120 (49) 120 (49) 50-99 100 (38) 75 (24) 100 55 (13) 55 (13) 2. An iodine solution shall have a minimum temperature of 68°F (20°C)P minimum concentration between 12.5 ppm and 25 ppm, P and pH of 5.0 or less or a pH no higher than the level for which the manufacturer specifies for the solution to be effective; P 3. A quaternary ammonium compound solution shall have a minimum temperature of 75ºF (24ºC), P have a concentration as specified in DPH Rule 511-6-1-.07(6)(g) and as indicated by the manufacturer’s use directions included in the labeling, P and be used only in water with 500 ppm hardness or less or in water having a hardness no greater than specified by the EPA-registered label use instructions; P 4. If another solution of a chemical specified under paragraphs 1 through 3 of this subsection is used, the permit holder shall demonstrate to the Health Authority that the solution achieves sanitization and the use of the solution shall be approved; P 5. If a chemical sanitizer other than chlorine, iodine, or a quaternary ammonium compound is used, it shall be applied in accordance with the EPA-registered label use instructions ;P and 6. If a chemical sanitizer is generated by a device located on-site at the food service establishment, it shall be used as specified in 1-5 of this subsection and shall be produced by a device that: (i) complies with law as specified in sections 2(q)(1) and 12 of the Federal Insecticide, Fungicide, and Rodenticide Act (FIFRA), P (ii) complies with 40 CFR 152.500 Requirement for Devices and 40 CFR 156.10 Labeling Requirements, P (iii) displays the EPA device manufacturing facility registration number on the device, Pf and (iv) is operated and maintained in accordance with manufacturer’s instructions. Pf. 7. On-site chemical sanitizer generating equipment with active ingredients, such as copper, must be registered as pesticides. The active ingredient may be part of the equipment or separately added. New Violation. Correct By: 09/18/2026Official report · Item 4-2B ↗
Correct by
Observed salmon thawed in WIC while still in vacuum sealed packaging. COS: PIC removed tuna from vacuum sealed packaging.
Code 511-6-1.04(6)(c)
Observed salmon thawed in WIC while still in vacuum sealed packaging. COS: PIC removed tuna from vacuum sealed packaging. 511-6-1.04(6)(c) - Thawing (C) (c) Thawing. Except as specified in paragraph 4 of this subsection, time/temperature control for safety food shall be thawed: 1. Under refrigeration that maintains the food temperature at 41°F (5°C) or less; PF or 2. Completely submerged under running water: (i) At a water temperature of 70°F (21°C) or below, PF (ii) With sufficient water velocity to agitate and float off loose particles in an overflow PF, and (iii) For a period of time that does not allow thawed portions of ready-to-eat food to rise above 41°F (5°C), or (iv) For a period of time that does not allow thawed portions of a raw animal food requiring cooking to be above 41°F (5°C), for more than 4 hours including: (I) The time the food is exposed to the running water and the time needed for preparation for cooking PF, or (II) The time it takes under refrigeration to lower the food temperature to 41°F (5°C) PF; 3. As part of a cooking process if the food that is frozen is: (i) Cooked as specified under subsections (5)(a)1 or 2 or (5)(b) or 5(e) of this Rule PF, or (ii) Thawed in a microwave oven and immediately transferred to conventional cooking equipment, with no interruption in the process PF; or 4. Using any procedure if a portion of frozen ready-to-eat food is thawed and prepared for immediate service in response to an individual consumer's order. 5. Reduced oxygen packaged fish that bears a label indicating that it is to be kept frozen until time of use shall be removed from the reduced oxygen environment: (i) Prior to its thawing under refrigeration that maintains the food temperature at 41°F (5°C) or less; or (ii) Prior to, or immediately upon completion of its thawing, using procedures to completely submerge in running water as specified in paragraph 2 of this subsection. Corrected On-Site. New Violation.Official report · Item 11C ↗
Observed lack of quat test strips inside facility. CA: Advised PIC to obtain quat test strips if using quat sanitizer.
Code 511-6-1.05(3)(h),(i),(j)
Observed lack of quat test strips inside facility. CA: Advised PIC to obtain quat test strips if using quat sanitizer. 511-6-1.05(3)(h),(i) - Temperature Measuring Device, Manual Warewashing; Sanitizing Solutions, Testing Device (Pf) (h) Temperature Measuring Devices, Manual and Mechanical Warewashing. 1. In manual warewashing operations, a temperature measuring device shall be provided and readily accessible for frequently measuring the washing and sanitizing temperatures. Pf 2. In hot water mechanical warewashing operations, an irreversible registering temperature indicator shall be provided and readily accessible for measuring the utensil surface temperature. Pf (i) Sanitizing Solutions, Testing Devices. A test kit or other device that accurately measures the concentration in mg/L of sanitizing solutions shall be provided. Pf New Violation. Correct By: 09/18/2026Official report · Item 15B ↗
Correct by
Observed final rinse gauge not in operation on WW machine. CA: Advised PIC to get WW machine serviced to fix final rinse temperature gauge.
Code 511-6-1.05(6)(j)
Observed final rinse gauge not in operation on WW machine. CA: Advised PIC to get WW machine serviced to fix final rinse temperature gauge. 511-6-1.05(6)(j) - Mechanical Warewashing, Wash Solution Temperature (Pf) (j) Mechanical Warewashing Equipment, Wash Solution Temperature. 1. The temperature of the wash solution in spray type warewashers that use hot water to sanitize may not be less than: (i) For a stationary rack, single temperature machine, 165ºF (74ºC); Pf (ii) For a stationary rack, dual temperature machine, 150ºF (66ºC); Pf (iii) For a single tank, conveyor, dual temperature machine, 160ºF (71ºC) ; Pf or (iv) For a multitank, conveyor, multitemperature machine, 150ºF (66ºC). Pf 2. The temperature of the wash solution in spray-type warewashers that use chemicals to sanitize may not be less than 120ºF (49ºC). Pf New Violation. Correct By: 09/18/2026Official report · Item 15B ↗
Correct by
Correction and repeat labels quote the report. An absent label leaves correction status unknown; a deadline does not confirm a correction.
Fulton County · Sep 17, 2026
02 / Same facility ↗Official inspection historyAvailable records for this official facility
03 / How scoring works ↗Georgia’s food-service rulesScores and findings describe the dated inspection, not current operating conditions. A correction deadline does not establish whether an issue remained unresolved afterward.
Findings quote the official report captured . “Corrected on site” and “repeat” reflect explicit report markers. “COS” and “CA” in the inspector’s notes refer to corrections and corrective actions; an instruction to act is not proof that it was completed.
History links the same official facility ID within the issuing authority and may omit intervening inspections. Same-day results have no inferred sequence. Report excerpts follow source order, not a severity ranking.
This report comes from Fulton County. History includes only this authority’s exact facility ID.
Checked