Dosa Boti received a B, scoring 84 out of 100, in a Fulton County food-service inspection on Aug 20, 2026. The official report lists six findings. [1]
The inspector observed both the hand sinks in the kitchen and front service area are not accesible, there were utensils placed inside the hand sinks. [2]
The inspector also observed RIC cooler has foods like tomatoes, heavy cream not maintaining temperatures at or below 41F. [3]
The report states: “At the time of inspection most recent inspection report was not posted.” [4]
The report marks two findings as corrected on site. [5]
Showing 6 of 6 findings
Observed both the hand sinks in the kitchen and front service area are not accesible, there were utensils placed inside the hand sinks. PIC advised to clear the hand sink.
Code 511-6-1.06(2)(o)
Observed both the hand sinks in the kitchen and front service area are not accesible, there were utensils placed inside the hand sinks. PIC advised to clear the hand sink. 511-6-1.06(2)(o) - Using a Handwashing Sink- Operation & maintenance (Pf) (o) Using a Handwashing Sink. 1. A handwashing sink shall be maintained so that it is accessible at all times for employee use. Pf 2. A handwashing facility may not be used for purposes other than handwashing. Pf 3. An automatic handwashing facility shall be used in accordance with manufacturer’s instructions. Pf Corrected On-Site. New Violation.Official report · Item 2-2D ↗
Observed RIC cooler has foods like tomatoes, heavy cream not maintaining temperatures at or below 41F. PIC advised to fix the cooler.
Code 511-6-1.04(6)(f)
Observed RIC cooler has foods like tomatoes, heavy cream not maintaining temperatures at or below 41F. PIC advised to fix the cooler. 511-6-1.05(6)(n) - Manual and Mechanical Warewashing Equipment, Chemical Sanitization-Temperature, pH, Concentration, Hardness (P,Pf) (n) Manual and Mechanical Warewashing Equipment, Chemical Sanitization - Temperature, pH, Concentration, and Hardness. A chemical sanitizer used in a sanitizing solution for a manual or mechanical operation at contact times specified under subsection (8)(b)3 of this Rule shall meet the requirements specified in DPH Rule 511-6-1-.07(6)(g), shall be used in accordance with the Environmental Protection Agency (EPA)-registered label use instructions P, and shall be used as follows: 1. A chlorine solution shall have a minimum temperature based on the concentration and pH of the solution as listed in the following chart; P Concentration Range Minimum Temperature MG/L PH 10 or less oF (oC) PH 8 or less oF (oC) 25-49 120 (49) 120 (49) 50-99 100 (38) 75 (24) 100 55 (13) 55 (13) 2. An iodine solution shall have a minimum temperature of 68°F (20°C)P minimum concentration between 12.5 ppm and 25 ppm, P and pH of 5.0 or less or a pH no higher than the level for which the manufacturer specifies for the solution to be effective; P 3. A quaternary ammonium compound solution shall have a minimum temperature of 75ºF (24ºC), P have a concentration as specified in DPH Rule 511-6-1-.07(6)(g) and as indicated by the manufacturer’s use directions included in the labeling, P and be used only in water with 500 ppm hardness or less or in water having a hardness no greater than specified by the EPA-registered label use instructions; P 4. If another solution of a chemical specified under paragraphs 1 through 3 of this subsection is used, the permit holder shall demonstrate to the Health Authority that the solution achieves sanitization and the use of the solution shall be approved; P 5. If a chemical sanitizer other than chlorine, iodine, or a quaternary ammonium compound is used, it shall be applied in accordance with the EPA-registered label use instructions ;P and 6. If a chemical sanitizer is generated by a device located on-site at the food service establishment, it shall be used as specified in 1-5 of this subsection and shall be produced by a device that: (i) complies with law as specified in sections 2(q)(1) and 12 of the Federal Insecticide, Fungicide, and Rodenticide Act (FIFRA), P (ii) complies with 40 CFR 152.500 Requirement for Devices and 40 CFR 156.10 Labeling Requirements, P (iii) displays the EPA device manufacturing facility registration number on the device, Pf and (iv) is operated and maintained in accordance with manufacturer’s instructions. Pf. 7. On-site chemical sanitizer generating equipment with active ingredients, such as copper, must be registered as pesticides. The active ingredient may be part of the equipment or separately added. New Violation. Correct By: 08/27/2026Official report · Item 6-1A ↗
Correct by
At the time of inspection most recent inspection report was not posted. 511-6-1.02(1)(d) - Displaying of the Inspection Report (C) 1.
Code 511-6-1.02(1)(d)
At the time of inspection most recent inspection report was not posted. 511-6-1.02(1)(d) - Displaying of the Inspection Report (C) 1. The most current inspection report shall be prominently displayed in public view at all times, within fifteen feet of the front or primary public door and between five feet and seven feet from the floor and in an area where it can be read at a distance of one foot away. 2. Food service establishments with drive-thru windows will post the current inspection report, and also have the inspection report posted so that a minimum of the top one-third of a copy of the current inspection report is visible through each window allowing customers to easily read the score, date of inspection and establishment information. 3. At food service establishments with no primary or public door, the current inspection report shall be prominently displayed at all times where the documents can be read by the public from a distance of one foot away. If requirements of this paragraph are not possible because of physical restrictions, a location will be determined as approved by the Health Authority. 4. The most current inspection report for mobile food service units and extended food service units issued by the local Health Authority having jurisdiction for its inspections shall be prominently displayed in public view during all hours of operation. Such inspection reports shall be prominently displayed at the point of service where the documents can be read by the public from a distance of one foot away. 5. A food service establishment inspection report addendum need not be displayed, but shall be made available by the food service establishment to the public upon request. New Violation. Correct By: 08/21/2026Official report · Item 13A ↗
Correct by
Observed scoops with no handles and touching food are used in the flour and sugar in the dry storage. PIC advised use the proper scoopers with handles.
Code 511-6-1.04(4)(k)
Observed scoops with no handles and touching food are used in the flour and sugar in the dry storage. PIC advised use the proper scoopers with handles. 511-6-1.04(4)(k) - In-Use Utensils, Between-Use Storage (C) (k)Storage of In-Use Utensils. During pauses in food preparation or dispensing, food preparation and dispensing utensils shall be stored: 1.Except as specified under paragraph 2 of this subsection, in the food with their handles above the top of the food and the container; 2.In food that is not time/temperature control for safety food with their handles above the top of the food within containers or equipment that can be closed, such as bins of sugar, flour, or cinnamon; 3.On a clean portion of the food preparation table or cooking equipment only if the in-use utensil and the food-contact surface of the food preparation table or cooking equipment are cleaned and sanitized at a frequency specified under DPH Rule 511-6-1-.05(7)(b) and (8)(a); 4.In running water of sufficient velocity to flush particulates to the drain, if used with moist food such as ice cream or mashed potatoes; 5. In a clean, protected location if the utensils, such as ice scoops, are used only with a food that is not time/temperature control for safety food; or 6. In a container of water if the water is maintained at a temperature of at least 135°F (57°C) and the container is cleaned at a frequency specified under DPH Rule 511-6-1-.05(7)(b)3(vi). Corrected On-Site. New Violation.Official report · Item 14A ↗
At the time of inspection PIC was unable to provide testing strips to test the sanitizer in 3 comp sink. 511-6-1.05(3)(h),(i),(j) - Temperature Measuring Device, Manual Warewashing; Sanitizing Solutions, Testing Device (Pf) (h) Temperature Measuring Devices, Manual and Mechanical Warewashing.
Code 511-6-1.05(3)(h),(i),(j)
At the time of inspection PIC was unable to provide testing strips to test the sanitizer in 3 comp sink. 511-6-1.05(3)(h),(i),(j) - Temperature Measuring Device, Manual Warewashing; Sanitizing Solutions, Testing Device (Pf) (h) Temperature Measuring Devices, Manual and Mechanical Warewashing. 1. In manual warewashing operations, a temperature measuring device shall be provided and readily accessible for frequently measuring the washing and sanitizing temperatures. Pf 2. In hot water mechanical warewashing operations, an irreversible registering temperature indicator shall be provided and readily accessible for measuring the utensil surface temperature. Pf (i) Sanitizing Solutions, Testing Devices. A test kit or other device that accurately measures the concentration in mg/L of sanitizing solutions shall be provided. Pf j) Cleaning Agents and Sanitizers. 1. Cleaning agents that are used to clean equipment and utensils as specified under section (7) of this Rule, shall be provided and available for use during all hours of operation. Pf 2. Except for those that are generated on-site at the time of use, chemical sanitizers that are used to sanitize equipment and utensils, as specified under Section (8) of this Rule, shall be provided and available for use during all hours of operation. Pf New Violation. Correct By: 08/24/2026Official report · Item 15B ↗
Correct by
Observed microwave in front food service has food accumulated. PIC advised to clean the non food contact surfaces regularly.
Code 511-6-1.05(7)(a)2,3
Observed microwave in front food service has food accumulated. PIC advised to clean the non food contact surfaces regularly. 511-6-1.05(7)(a)2,3 - Equipment, Food/Nonfood-Contact Surfaces, and Utensils, food-contact surfaces of cooking equipment & nonfood-contact surfaces free of accumulations (C) 2. The food-contact surfaces of cooking equipment and pans shall be kept free of encrusted grease deposits and other soil accumulations. 3. Nonfood-contact surfaces of equipment shall be kept free of an accumulation of dust, dirt, food residue, and other debris. New Violation. Correct By: 08/21/2026Official report · Item 15C ↗
Correct by
Correction and repeat labels quote the report. An absent label leaves correction status unknown; a deadline does not confirm a correction.
Fulton County · Aug 20, 2026
02 / Same facility ↗Official inspection historyAvailable records for this official facility
03 / How scoring works ↗Georgia’s food-service rulesScores and findings describe the dated inspection, not current operating conditions. A correction deadline does not establish whether an issue remained unresolved afterward.
Findings quote the official report captured . “Corrected on site” and “repeat” reflect explicit report markers. “COS” and “CA” in the inspector’s notes refer to corrections and corrective actions; an instruction to act is not proof that it was completed.
History links the same official facility ID within the issuing authority and may omit intervening inspections. Same-day results have no inferred sequence. Report excerpts follow source order, not a severity ranking.
This report comes from Fulton County. History includes only this authority’s exact facility ID.
Checked